General requirements

013 QUALITY ASSURANCE
01301 Submittals and Substitutions
013011 Submittals

The minimum acceptable qualities of materials and workmanship have been established in this Technical specification by reference to accepted standards, codes or descriptions of required performance. The Engineer has established requirements in each section for the advance submittal of data for review and approval. Such required data shall be submitted and reviewed and resubmitted as frequently as required until compliance with the specific requirements has been obtained.

Each data for submittal shall be carefully reviewed and verified for its compliance with the specific requirement of the submittals called for in each section of this Specification.

The approval by the Engineer of submittals is in no way considered as a guarantee or relief from replacing, the materials supplied or work executed, if the materials and workmanship are found defective by tests carried out there after. Such materials and workmanship found to be defective shall be replaced at no cost to the Investor.

All data, samples, test results, certificates, designs, drawings, etc., to be submitted shall fully comply with the requirements as specified in each section of this Specification.

Data and document accompanying samples of materials for submittals shall be signed by the contractor as proof of their being submitted for the specific work under consideration.

The document shall bear, the date, reference of section to this Specification and other requirement as specified in the particular sections of this Specification.
Schedule of submittals required by the Technical specification shall be prepared and submitted to the Engineer in two copies immediately after the signature of agreement.