R4-021713 UE Timer accuracy (CR 482r1 to 25.133 R99) (Ericsson)
R4-021714 UE Timer accuracy (CR 491r1 to 25.133 Rel-4) (Ericsson)
R4-021715 UE Timer accuracy (CR 483r1 to 25.133 Rel-5) (Ericsson)
No comments
Decision: The CRs are agreed
R4-021403 Correction of interruption time in FDD/FDD Hard Handover (CR 437r1 to 25.133 R99) (Panasonic)
R4-021404 Correction of interruption time in FDD/FDD Hard Handover (CR 438r1 to 25.133 Rel-4) (Panasonic)
R4-021405 Correction of interruption time in FDD/FDD Hard Handover (CR 439r1 to 25.133 Rel-5) (Panasonic)
No comments
Decision: The CRs are agreed
R4-021500 Total received power density definition for the BS (CR 498 to 25.133 Rel-5) (Nokia)
Moray Rumnay (Agilent) questioned what is the decision point for measuring this parameter.
Yannick Le Pezennec (Vodafone) noted that the corresponding CR in WG1 is for Rel-4.
Nokia and Agilent clarified that Io and Iob are to be interpreted as measured through an RRC filter at the chip decision points, although it was considered not essential to add the clarification to the specification. Nokia commented that the reference point is already approved in WG1. Measurement is defined within the bandwidth by the receiver pulse shaping filter but the reference point for the measurement is the Rx antenna connector.
Decision: The CR will be revised and a Rel-4 CR will be produced
Dostları ilə paylaş: | 
