Aci 315-99 supersedes aci 315-92 and became effective August 31, 1999



Yüklə 1,11 Mb.
Pdf görüntüsü
səhifə43/46
tarix13.09.2022
ölçüsü1,11 Mb.
#117756
1   ...   38   39   40   41   42   43   44   45   46
ACI 315-99 Details and Detailing of Concrete Reinforcement

 315-34
MANUAL OF CONCRETE PRACTICE
Fig. 11—ACI requirements for anchorage of open stirrups.
Fig. 12—Recommended two-piece closed single and multiple U-stirrups.


 315-35
DETAILS AND DETAILING OF CONCRETE REINFORCEMENT
Fig. 13—Standard column ties applicable for either preassembled cages or field erection.
Notes:
1. Alternate position of hooks in placing successive sets of ties.
2. Minimum lap shall be 12 in. (300 mm).
3. indicates bundled bars. Bundles shall not exceed four bars.
4. Elimination of tie for center bar in groups of three limits clear spacing to be
6 in. (150 mm) maximum. Unless otherwise specified, bars should be so
grouped.
5. Note to Architect/Engineer: Accepted practice requires that design draw-
ings show all requirements for splicing column verticals, that is, type of splice,
lap length if lapped, location in elevation, and layout in cross section.
6. Note to Detailer: Dowel erection details are required for any design
employing special large vertical bars, bundled vertical bars, staggered splices,
or specially grouped vertical bars as shown.
7. Bars must be securely supported to prevent displacement suring concreting.
8. Tie patterns shown may accomodate additional single bars between tied
groups provided clear spaces between bars do not exceed 6 in. (150 mm).
9. Minimum cover to ties, 11/2 in. (40 mm) for nonprestressed cast-in-place
concrete.
10. Spaces between corner bars and interior groups of three and between
interior groups may vary to accomodate average spacing > 6 in. (150 mm).
11. For average spacing < 6 in. (150 mm), one untied bar may be located
between each tied group of three and between a tied group and a corner bar.
A different pattern of ties may be substituted
provided that details of the requirements are
shown on the contract drawings. Single-leg tie
arrangements instead of the one piece diamond
tie shown are an acceptable alternate.



Yüklə 1,11 Mb.

Dostları ilə paylaş:
1   ...   38   39   40   41   42   43   44   45   46




Verilənlər bazası müəlliflik hüququ ilə müdafiə olunur ©muhaz.org 2024
rəhbərliyinə müraciət

gir | qeydiyyatdan keç
    Ana səhifə


yükləyin